HVAC Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== M3i ======

===== Reset Password =====

To reset and set up M-Password: 

  * Select Start > Programs > JCI > M-Password > Config. Leave User Name blank and use a Password of JCI, click OK 
  * Remove all entries in M-Password Config and save. 
  * Open Explorer, search for *.sec files, delete all of them, then reboot. 
  * Open M-Password Config and it should be titled Untitled. If not, remove all entries in M-Password Config and save, delete all *.sec files, reboot, re-open M-Password Config and it should be titled Untitled. 
  * Insert a New User. 
     * Select Edit > Application Actions and on the right will be Default and the User. 
     * Highlight Default user and move all actions to Default user, except for M3HCI, only move its Launch and Exit. 
     * Then highlight the User and only move all of M3HCI. Click OK on the Actions window. 
  * Save M-Password Config in the project's folder. 
  * Double-click or Right-click and Edit the User on the right. Remember the User Name, enter a Password and again in Verify Password. 
  * Select the Points tab, for Include enter an * and select Add. 
  * Select the Files tab, for Include enter *.* and select Add, then select OK. 
  * Save and Exit M-Password Config. 
  * For this first time, select Start > Programs > JCI > M-Password > Login and enter the User's Name and Password, then open M3. 
  * Select M3Options > System Setup > Login on Launch and Logout on Exit - Always, then OK. 
  * Close M3 and wait for the MWorkstation Communication to open and close. 
  * Reopen M3, it will ask you to login, M3 will open. Then close M3, it will logout of M-Password. If the above works, then you can proceed. 
  * Open M-Password Config, add other Users, add Groups and restrict Actions. Remove the Actions of the Default user to restrict all users. 
  * Save M-Password Config before exiting.